This section describes the steps required to restore HA broker cluster from backup.
The detailed instructions how to perform backup on replicated environment can be found here.
At this point we assume that backups are collected on regular basis from Master node.
Replication configuration of a cluster is stored internally in HA message store. This information includes IP addresses of the nodes. In case when HA message store needs to be restored on a different host with a different IP address the cluster replication configuration should be reseted in this case
Oracle provides a command line utility
to reset the members of a replication group and replace the group with a new group consisting of a single new member
as described by the arguments supplied to the utility
Cluster can be restored with the following steps:
Copy log files into the store folder from backup
DbResetRepGroup to reset an existing environment. See an example below
Example 13.9. Reseting of replication group with
In the example above
DbResetRepGroup utility from Berkeley JE of version 5.0.73 is used to reset the store
at location ha-work/Node-5001/bdbstore and set a replication group to TestClusterGroup
having a node Node-5001 which runs at localhost:5001.
Start a broker with HA store configured as specified on running of
Start replica nodes having the same replication group and a helper host port pointing to a new master. The store content will be copied into Replicas from Master on their start up.
Apache Qpid, Messaging built on AMQP; Copyright © 2015 The Apache Software Foundation; Licensed under the Apache License, Version 2.0; Apache Qpid, Qpid, Qpid Proton, Proton, Apache, the Apache feather logo, and the Apache Qpid project logo are trademarks of The Apache Software Foundation; All other marks mentioned may be trademarks or registered trademarks of their respective owners